R
Roel Huis in ‘t Veld
Director, Kriya Materials · Week of October 5, 2026
Decoration is becoming a functional layer
Two press releases from Kurz ahead of Fakuma, which opens in Friedrichshafen on 13 October, say more about where surface finishing is going than most conference talks. One shows contour-following roll-on hot stamping that puts a premium finish on a curved 3D part. The other shows a thin PET protective layer finish on a car key moulded from post-industrial recycled plastic, and a 3K in-mould decoration demonstrator that combines decoration, function and surface protection in a single cycle, on recycled rPET and natural-fibre substrates.
My reading is simple: when the bulk polymer is recycled, the surface has to do the work the virgin material used to do.
Think about what a recycled or natural-fibre part cannot do on its own. It does not have the gloss, it does not have the scratch resistance, it may not have the colour consistency, and nobody is going to specify it for a visible part unless somebody fixes that. The fix is a few microns of transfer layer. That layer now carries the appearance, the hard coat, often an optical function like a light guide or a rear-light pattern, and increasingly the electronics, with LED films and functional foil bonding on curved surfaces. The moulding is becoming a carrier; the value is moving into the layer that is applied to it.
This is a change in who buys what. For decades a decorative foil was a cosmetic purchase made late in the project by the people responsible for appearance.
A functional transfer layer is a technical purchase made early by the people responsible for durability, optics and recyclability. Those are different buyers, with different test plans and different attitudes to the chemistry inside the layer. They want to know what the hard coat is, what the primer is, whether the whole stack can be separated for recycling and, in Europe, whether there is anything fluorinated in it.
That last point is where I see the real shift. The specialty resins inside these layers used to be invisible to the OEM. They came in through the converter and nobody asked. Now the converter is being asked, and so converters are asking us. My expectation is that specialty coating resins will be specified by the converters long before most OEMs could name what they contain, because the converter is the one who has to make the process run at a 120-second cycle time and still pass the scratch test.
For a materials company the lesson is to stop thinking of decoration and function as separate markets. The same film stack that makes a recycled part look premium is the one that keeps it from scratching and, in the next step, lights it up.
If you supply one layer of that stack and you are not talking to the people who own the other layers, you better start doing that.
Fakuma is a plastics show, but for us it is a coatings show, and I will be reading the demonstrators with that in mind.
Sources:
Contour-following roll-on hot stamping (CATWALK, with Deckerform) and the Arburg car key with Protective Layer Finish on post-industrial recycled plastic; quote from Johannes Romming: Kurz press release, 29 Sep 2026 — "Driving innovation together: KURZ showcases strong partner projects at FAKUMA"
3K IMD demonstrator combining decoration, function and surface protection; IMD VARIOFORM cycle time under 120 seconds; rear-light concept with ALIYOS LED films and Functional Foil Bonding; NFPP natural-fibre composites, RECOSYS rPET take-back material, EcoLayer FX; Hall A4, Stand 4204: Kurz press release, 22 Sep 2026 — "LEONHARD KURZ will be showcasing surface finishes for series production at FAKUMA 2026"
Fakuma 2026 dates, 13–17 October, Friedrichshafen: EventsEye listing (or cite the organiser, fakuma-messe.de, which I could not open from here)
Kurz newsroom index, in case you want a single landing link: Kurz press releases