Building Energy Calculator

Quantify the impact of solar heat control glazing on your building's energy consumption, CO&sub2; footprint, and operational costs.

Based on validated TNO/BMC simulations across 10 cities worldwide. Laminated DGU and laminated DGU + low-e configurations.

場所を選択してください

ガラス構成

ATO 中間層

ATO + Low-e 組み合わせ

SHGCが低い方がより多く省エネになる場合があるのはなぜですか?

ATOの各ステップは同時に2つの効果をもたらします。近赤外線の熱を遮断し(SHGCが低下 → 冷房負荷の削減)、かつ可視光透過率が低下します(Tvisが低いほど人工照明が増加します)。

冬が寒い温帯気候(イスタンブール、マドリード)では、SHGCが低いと冬季の太陽熱取得も減少し、暖房負荷が増加します。冷房節約、暖房コスト、照明コストのバランスが取れる最小kWh構成は、多くの場合最低SHGCではありません。

結果パネルに表示される総kWhが最小になるよう最適化してください。SHGCチップが最低の値ではなく、総kWhを基準にしてください。Low-eバリアントが利用可能な場合は追加してください。U値の低下(2倍以上)により、冬季暖房ロスを取り戻せることが多いです。

建物パラメータ

80
1100
463m²
100 m²1,500 m²

ガラス性能 — Kriya 1.5w% + Low-e

Visible light transmission(Tvis)28%
Solar heat gain coefficient(SHGC)0.21
U値1.1 W/m²K
Low-eコーティングあり(SN68)
ATO濃度1.5w%

エネルギー削減

47.8%

シンガポールにおけるKriya 1.5w% + Low-e使用時、年間エネルギー消費量を最大47.8%削減できます

年間CO₂削減量

1,706Mt

年間CO₂換算排出量

年間コスト削減額

€564,961

$0.18/kWh 基準(シンガポール)

年間エネルギー消費量 — 80階建てビル

標準DGU(遮熱なし)7,138,640 kWh
Kriya 1.5w% + Low-e使用時3,727,040 kWh
3,411,600 kWh年間節約量

シンガポールのエネルギー状況

電力料金

$0.18

kWh あたり

CO₂排出原単位

500

gCO₂/kWh

ガラス面積合計

37,040

m²

1.

標準化された建物モデル(1フロア、5室、全面ガラスファサード、15.2 x 30.5 m)を使用したTNO/BMCの独立エネルギーシミュレーションに基づいています。複数フロアの結果は、検証済みの単一フロアデータから線形スケーリングされています。

2.

実際の性能は、建物の向き、使用パターン、HVACシステムの効率、および現地の気象条件によって異なります。表示される結果は参考値であり、建物固有のエネルギー評価の代替としてご使用にならないようにしてください。

3.

CO₂削減量およびコスト削減額は、場所固有の電力料金および系統排出係数を使用して算出しています。通貨換算は概算です。

Simulation methodology

Building model

Energy simulations were independently performed by TNO/BMC (Netherlands Organisation for Applied Scientific Research / Building Model Consultants) using a standardised building model.

  • •1 floor, 5 rooms (15.2 × 30.5 m)
  • •All-glass facade, 2.4 m height
  • •Heating trigger: ≤ 21 °C / Cooling trigger: ≥ 24 °C
  • •Glass: laminated DGU (7.26/13/3 mm) and laminated DGU + low-e

Scaling approach

The calculator scales validated single-floor simulation results linearly by the number of floors and glass area. The reference impact model uses an 80-floor building with 37,088 m² total glass area (approximately 463 m² per floor).

Local factors

CO&sub2; reductions are calculated using location-specific grid emission factors. Cost savings use local electricity prices. Both factors are based on data from the original TNO/BMC study and may differ from current market conditions.

See also

Automotive Thermal Management Calculator

Calculation Model 887 — quantify the impact of ATO glazing on EV range, cabin temperature, and fleet CO&sub2; penalties.

Open calculator